• Products

    The store is temporarily closed while we are moving shop! Please check back later.

    Displaying 1–7 of 7
    • Audi 7A Cams for Inline 5 20V

      Audi 7A Cams for Inline 5 20V All camshafts are used and in good usable condition. Pulled from engines with roughly 100-200K miles. Image is representative of typical condition. Please contact us for any special requirements you may have. Camshaft Specifications: Intake cam: 7A 054109021 Opens 6° ATDC, closes 38° ABDC, duration 224°, lift 9.6mm […]

    • Audi C4 urS4/urS6 Caliper Brackets

      We are pleased to offer a low cost custom solution for the variety of possible permutations of strut uprights, bearing housings, hubs, calipers, and rotors used by builders today. There are a number of available options, mostly based on the RS2 caliper bracket used by Audi/Porsche to fit the original Porsche calipers on the legendary […]

    • Audi ur quattro Trunk Decal Set – Replica

      This is a set of replica decals for the iconic Audi ur quattro. The early cars had these factory installed decals instead of the raised emblems that came on the later cars. These are created in the standard quattro font at a size near to the original decals. Decals are precision-cut from high quality outdoor […]

    • Brake Caliper Brackets – Audi B3/B4

      We are pleased to offer a low cost custom solution for the variety of possible permutations of strut uprights, bearing housings, hubs, calipers, and rotors used by builders today. There are a number of available options, mostly based on the RS2 caliper bracket used by Audi/Porsche to fit the original Porsche calipers on the legendary […]

    • Coilover Perch Rings – Weld On

      These solid steel precision machined rings can be welded to your existing strut uprights (after removing stock coil spring perches) to provide a perch for the threaded collars used for the coilovers. These are set up for use on all Audi strut assemblies used on the B2, B3, B4 and urS C4 (front only) chassis […]

    • Hubs – Machined urS4/6

      These hubs are cleaned up and can be machined for use in small chassis bearing carriers as a popular low cost and readily available alternative to the S2 front hubs for changing your car hub bolt pattern from 4X108 to 5X112. These hubs sit inboard approximately 5mm from the standard S2/CQ hubs, so a spacer […]

    • Washer – Cylinder Head – Audi Sport Quattro

      Using ARP or similar high strength head clamping hardware in your performance engine build is a good choice. However, when clamping down with increased force on the soft aluminum seating surfaces of an alloy head, such as that found in the I5 20VT engines, problems can arise due to the small clamping area of the […]